How to stop breaking at reset

Discussion in 'C' started by RouseA, Aug 28, 2010.

  1. RouseA

    RouseA Guest

    I am developing a number of projects for STM32 processors using Eclipse, gcc, gdb and an Olimex ARM-USB-OCD jTag dongle.

    All works well, but every time I relaunch the project in debug mode the code stops at address 0x08000000. The debug window displays 'No source available for "g_pfnVectors() " '. I can run the program to proceed to the next breakpoint, but it is a minor annoyance that this always happens. Furthermore I suspect it is using up one of the 6 breakpoints provided by the STM32, which restricts debugging.

    I launch gdb with the following commands:

    target remote localhost:3333
    monitor reset init
    load
    monitor reset init
    break main

    The first breakpoint it should hit is therefore at main(), which is where it stops after breaking at 0x08000000. If I add 'continue' at the end of the gdb commands it doesn't break at 0x08000000, nor at main(), and not even at any other breakpoints I may have manually added!

    Any ideas would be welcomed
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice