serial port programming

Discussion in 'Meet and Greet' started by a8083, Nov 28, 2007.

Thread Status:
Not open for further replies.
  1. a8083

    a8083 New Member

    Joined:
    Nov 27, 2007
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    0
    10



    hello
    I want to write an application to send & receive data through serial com port. I am using VC++ net 2003. i have successfully intialized com port & set the DCB.but problem is that when i send packet at baud rate 9600 then it reads correct data byte. but for 1200 baud rate it doesnt read correct data byte. It miss the data byte for 1200 baud rate.
     
    a8083, Nov 28, 2007
    SHARE #1
  2. shabbir

    shabbir Administrator Staff Member

    Joined:
    Jul 12, 2004
    Messages:
    15,375
    Likes Received:
    388
    Trophy Points:
    83
    Duplicate of serial port programming. Thread closed. Also I have moved the other thread in the right forum and again you have created the thread in the wrong forum. Make sure you learn to read the responses.
     
    shabbir, Nov 28, 2007
    SHARE #2
Thread Status:
Not open for further replies.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice