1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

relocatable program using assembly instructions with a seven segment display

Discussion in 'Assembly Language Programming (ALP) Forum' started by soake, May 22, 2009.

  1. soake

    soake New Member

    Joined:
    May 22, 2009
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    0
    I am a little confused with instructions on how to get a seven segment display to show the words SLO using hexadecimal in a simulator processor...

    I have started with load immediate r1 ....
    load immediate r2....
    load immediate r3....

    but how do i get this to store and display these????

    i am very confused.

    please could someone guide me in placing addresses and instructions... I am very confused

    thank you
     
  2. xpi0t0s

    xpi0t0s Mentor

    Joined:
    Aug 6, 2004
    Messages:
    3,012
    Likes Received:
    203
    Trophy Points:
    0
    Occupation:
    Senior Support Engineer
    Location:
    England
    Depends very much on the hardware, or in this case the simulator. What simulator are you using?
     
  3. soake

    soake New Member

    Joined:
    May 22, 2009
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    0
    I managed to get the simulator to display SLO... its one thats been privately designed.

    The next step was trying to get that to connect with speed and to connect with displaying other signs... I couldnt figure that...

    thank you
     

Share This Page